Ethernet over E3 Switch (Ethernet over E3)
Product Overview
 

Aries Telecom offers its Ethernet to E3 Switch (Ethernet over E3 Switch) packaged in a 19-inch rack mountable chassis.

Aries Ethernet to E3 Switch (Ethernet over E3 Switch) provides a 100BaseT data interface on the user side which may be used to transport Ethernet traffic over a E3 link.

Ethernet over E3 Switch (Ethernet over E3)

Download Data Sheet of - Ethernet over E3 Switch (PDF)

Download Presentation - Ethernet over E3 Switch (PPS)

The converter provides a simple and cost effective method to convert and transport 100BaseT ethernet data over a E3 link.

Aries offers its Ethernet to E3 Switch (Ethernet over E3 Switch) packaged in a 19-inch 1U (44mm) high rack-mountable chassis.

Aries Ethernet to E3 Switch (Ethernet over E3 Switch) provide a 100BaseT data interface which may be used to transport Ethernet traffic over an E3 link. The converter provides a simple and cost effective method to convert and transport 100BaseT ethernet data to an E3 stream. The converter may be accessed by the user for configuration and monitoring through a Windows based GUI that is shipped with the system. It may be also accessed remotely over a TCP-IP network.

Why we are better:

Our Ethernet over E3 equipment offers the following necessary features that similar equipment from the other manufacturers do not offer or support......

  • We offer the option of Framed E3 as well as Un-Framed E3 option. The framing option is user programmable and use may select the E3 interfaces as Framed E3 or Un-Framed E3.

          Note: Enabling the Framing option becomes essential when you inter-connect

          and use the equipment over an Sonet / SDH network. If you connect an Un- Framed E3 interface of the
          equipment to a Framed E3 network interface, the etwork is likely to show an error on the E3 interface.

  • Our equipment allows the user to connect to, configure and manage the equipment remotely over a TCP-IP network. Most of the equipment being offered by the competition does not offer this feature.

  • Our equipment supports efficient handling of data, even during data bursts. Our product design provides a very large buffer data storage capacity to allow for and handle any data bursts very efficiently.

  • Supports Jumbo Frames: Our equipment is equipped with a Committed Information Rate controller (CIR) which manages any data overflows through its 100MHz SDRAM controller which interfaces to a 32-bit wide 128 Mbit SDRAM. The SDRAM is used to buffer the data from the Ethernet and WAN ports for transport. It can accommodate up to 8192 frames with a maximum frame size of 2016 bytes to prevent any data overflows, or loss of packets in the event of a data burst.

Flow control is a part of basic ethernet communication protocol and the TCP-IP flow control protocol ensures that an optimum flow control is maintained at all times.

Note # 1: It is essential that the two routers / servers be operating in the same IP  

domain (subnet), since the Ethernet over E3 Switch simply interconnects two LANS over a E3 link. The Ethernet over E3 Switch does not do any routing function. It simply provides a bridge to inter-connect two LANs over a E3 link.

Note: The equipment should always be installed and used in pairs - with each unit to

be installed at either end of the E3 link.

Applications

  • 100 BaseT Ethernet to E3 Conversion (100BaseT over an E3 interface)
  • Ethernet over E3 converter - Remote LAN application
  • Ethernet over E3 converter - Remote LAN over wireless E3 application

Applications Diagrams

Features and Highlights

  • G.703 E3 34 Mbps to Ethernet interface converter
  • 100BaseT full duplex fast Ethernet in accordance with IEEE802.34, RJ-45
  • 100 Mbit/s full duplex Autonegotiation
  • Provides framed and un-framed E3 option
  • Stratum 3 Clock
  • Local & Remote access and monitoring with either RS232 or 10/100BaseT for remote management over TCP-IP network
  • Power Supply: -48V DC or AC power supply options available
  • Ethernet frame size: 2016 bytes (max)
  • Supports Jumbo Frames
  • Accommodates up to 8192 frames with a maximum frame size of 2016 bytes
  • Prevents any data overflows, or loss of packets in the event of a data burst.

Indications and Alarm Monitoring

  • E3 Loss of Signal
  • Loss of E3 frame (in framed E3 mode)
  • Loss of incoming signal at 100 BaseT Ethernet
  • Loss of ethernet packets, errored ethernet packets, over-sized  ethernet packets and under-sized ethernet packets log.
  • Configuration Error Alarm
  • Clock Status
  • +3 Volts Power Supply
  • -48V DC present
  • Configuration Error

Technical Specifications

DC Adapter Power Supply Specifications (DC Option)
Power Supply -48V DC (-40VDC to -60V DC)
Input DC Voltage -48V DC ( nominal)
Range of Input -40V to -60V DC
Output Voltage +3.3V
Full Load Output Current 2A at +3.3V
Input Voltage Reversal Protection Provided in the Card
Over Current Protection  2A for +3.3V
Short Circuit Protection Current limit - 3A. Recovers on removal of short
Under Voltage < 3.17V
Over Voltage 3.5V
Efficiency at full load >90%
Ripple at full load <5mVrms
Spike at full load <50mV
 
AC Adapter Power Supply Specifications (AC Option)
Input AC Voltage 100 - 240 Volt AC
Range of Input Voltage 100 V To 240 V AC
Output Voltage  7.5V DC to 9.0 V DC DC input polarity protection.
Maximum Full Load Output Current 2.5 A at 7.5V DC / 9.0 V DC
Input Voltage Reversal Protection Provided in the Card
Efficiency at full load  >86%

Chassis

1U High (42 mm)
19-inch rack-mounting shelf.

Power Supply

Power Supply -48V DC (-40V DC to -60V DC) (Optional)*
Power Supply  AC Input (Optional)*
* Please specify the Power Supply Option (AC or DC) which is required before placing the order.
Please see ordering information in this data sheet for details.

Power Consumption

Power Consumption  9 Watts

Number of Ethernet Interface

10/100BaseT (Electrical) 4
10/100BaseT Electrical + 100Base FX Optical 3 Electrical and 1 Optical

100BaseT Interface (Electrical Ethernet)

Interface Types 100BaseT
Standards Compliance IEEE 802.3-2002, RFC1662, RFC2615, X.86, RMII
Interface Rate 100BaseT limited to E3 transmission rate
Protocol HDLC/X.86 (LAPS) Encapsulation
Connectors RJ-45 (100 BaseT Electrical)

100BaseT-FX Interface (Optical Ethernet)

Interface Types 100BaseT-FX
Standards Compliance IEEE 802.3-2002, RFC1662, RFC2615, X.86, RMII
Interface Rate 100BaseT-FX optical limited to E3 transmission rate
Protocol HDLC/X.86 (LAPS) Encapsulation
Connectors SC

E3 Interface

Number of E3 Interfaces 1
Bit Rate 34.368 Mbps
Bit Rate Tolerance +/- 20ppm
Line Code HDB3
Frame Structure As per G.751
Interfaces As per G.703
Connectors BNC, Co-axial Un-balanced
Impedance 75 Ohms
Permissible Attenuation 12dB @ 17184 KHz
Signal Level to declare Loss of Signal condition -35dB (maximum)
Signal Level to clear Loss of Signal condition -15dB (minimum)

Clock

Internal System Internal Clock
Loop-Timed Timed from E3 Interface.

Management and Control

  • Serial Management Port - RS232 interface
  • 10/100 BaseT for Remote Management over a LAN.
  • 10/100 BaseT Telnet over a TCP-IP Network.

Command Language

Command Line Interface (English Text Commands)
Windows based GUI (optional).

NMS (with Telnet) XPort Specifications

Network Interface RJ-45 Ethernet 10BaseT or 100BaseT-TX (auto sensing)
Compatibility Ethernet Version 2.0 IEEE802.3
Protocols supported ARP, UDP/IP, TCP/IP, Telnet, ICMP, SNMP, DHCP, BOOTP, TFTP, Auto IP, SMTP and HTTP
LEDs 10Base-T & 100Base-TX Activity, Full/half duplex.
Management  Internal web server, SNMP (read only), Serial login, Telnet login
EMI Compliance
  • Radiated & conducted emissions - complies with Class B limits of EN55022:1998
  • Direct & Indirect ESD - complies with EN55024:1998
  • RF Electromagnetic Field Immunity - complies with EN55024:1998
  • Electrical Fast Transient/Burst Immunity - complies with EN55024:1998
  • Power Frequency Magnetic Field Immunity - complies with EN55024:1998
  • RF Common Mode Conducted Susceptibility - complies with EN55024:1998

Others Links

Technical specifications are subject to change without notice.
All brand names and trademarks are the property of their respective owners.

TOP

Ethernet over E3 Switch - Data Sheet (PDF)

Ethernet over E3 Switch (PPS)
Ethernet over FE1 Converter
Ethernet over E1 Converter

1 x E1 over Ethernet Multiplexer  
(TDM over IP)

2 x E1 over Ethernet Multiplexer
(TDM over IP)
8 x E1 over Ethernet Multiplexer (TDM over IP)
16 x E1 over Ethernet Multiplexer (TDM over IP)
Ethernet over 4 E1 Converter
Ethernet over SDH Converter
VCL-TP, Teleprotection
Equipment (C37.94 Optical Version)

VCL-TP, Teleprotection Equipment (G.703 64 Kbps Electrical Version)

Gigabit Ethernet over SDH
Other Link
VCL-MX Version 6 - 80 E1 Voice and Data Multiplexer
 VCL-MX Version 6 DXC - 80 E1, 160Mbps DXC Switch
STM-1, STM-4, STM-16 SDH Multiplexers
Multiplexers & Channel Bank
Monitoring Groomer Solution
TDM over IP Solutions
Optical Multiplexer
Teleprotection Equipment
Ethernet over SDH Converter
Ethernet over Multi E1 (ML- PPP) Converter
Digital Access Cross Connect (DXC)
    :: Application Diagram ::

Home    |   What's New   |   About Us   |   Contact Us   |   Products   |    Press   |   E-mail

Aries Telecom and Trading Corp.
PO Box 85680, Al-Jazeera Al-Hamra, Ras Al Khaimah, U.A.E.
Ph: +971 56 136 1308, Fax:  +971 43 631 147